jacdx Posted May 27, 2011 Share Posted May 27, 2011 Hey all,I have a TX-SR606 receiver (never again Onkyo) ...and none of the drivers I try will turn it on. As in, the IR bud doesn't even light up when I try. I control everything else on the receiver fine.Any ideas?Thx,-J Link to comment Share on other sites More sharing options...
PixelPerfect Posted May 27, 2011 Share Posted May 27, 2011 I had an issue like this a couple of times, I had to go back and edit the driver. The drivers were programed to treat the units as always on. Link to comment Share on other sites More sharing options...
jacdx Posted May 27, 2011 Author Share Posted May 27, 2011 Well after some more time screwing with it, I found out my connections were screwy. Once I solved that, the receiver does power on and off as needed. *However* the On/Off buttons in the Composer panel still don't do anything. Link to comment Share on other sites More sharing options...
zero327 Posted August 15, 2011 Share Posted August 15, 2011 I am having this problem. does anyone know how to edit the driver???? Link to comment Share on other sites More sharing options...
PixelPerfect Posted August 18, 2011 Share Posted August 18, 2011 Under the main menu right click the reciever and select edit driver. From there you can tell it to use on/off commands. Link to comment Share on other sites More sharing options...
zero327 Posted August 19, 2011 Share Posted August 19, 2011 Edit driver was grayed out, but my dealer figured it out with some changes in the onkyo menus. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.