Jump to content
C4 Forums | Control4

Event Programming for InHome Contact Switch


Bradmill

Recommended Posts

Hi,

Bought a Inhome Contact switch today, added it to my setup and the system design shows animation when the contact closes and opens.

But I was expecting to see under programming -> events -> contact device, something like Contact Open, Contact Close ?

So I could programme If OPEN do X, If CLOSE do Y ?

So not sure have you assign actions to contact events?

any help, screenshot would be great

Thanks

bradmill

Link to comment
Share on other sites


Bradmill,

The event is attach to the device that you are monitoring with the contacts, I mean, if for example you assigned ( connect )the doorbell to the InHome wireless sensor contac input 1, then the event will be when the doorbell is release or pressed and then the action that you desire. You must see the input as one in the controller.

hope this help.

Sysconio

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...