wick

 yup my bad    here is all the info  

  fireplace is a town an country tcws54 series 

  wall switch module  has no part number on it that i can see   but it has two rj45's on the back   one goes to the fireplace and one is an input from a home automation system .  according to the instructions  if i connect pin 8 ( which is the digital i/o for the flame ) to the common pin 1 and/or pin 5 it should turn on the power vent and then 15 secs later spark and ignite   it does not do that   if i do it thru my ea-5 relay  or me with a jumper  just holding the wires together     it does not fire up the power vent and thus no spark  

  or flame  

i have the cat termed in configuration "b"  as per the instructions and have made a test jumper to bypass my c4 relays and see if i done screwed that up, but seems like the module isnt doing what its supposed to do .   was hoping some guru on here has had this problem before and could point me in some direction

good day everyone    i have a random question that seems to have me and the fireplace guys both stumped....

     here it is   i have a town and country fireplace   with " wall switch"    and remote    it all works how it should   push a button and the power vent turns on and 15 sec later my igniter goes and there is flame  woo hooo!!!

   now the module is "integration ready" meaning if i connect  connect two  wires it should replicate what the remote does   but alas  it does not   i can get the module to beep but power vent does not power up and thus no flame  

    the manufaturer has tried to help but they make the fireplaces  the modules are from somewhere else  and there technical help is limited

   has any of u fine installers had an issue like this that could shed some light on this for me ????   it would be greatly appreciated