Meffx

On 5/1/2024 at 4:41 PM, mstafford388 said:

I'm assuming you're talking about inside the house?  You could disable the chime on the touchscreen then play an announcement. 

Yes, I mean the touch panel. Ok, so what dependency should trigger this?

Hey. Do you have any ideas to change the sound of doorstations (ding-dong)?

Ok, thank you very much for the suggestions. I understand that an infinite loop can crash the processor.

In general, I'm working on a project where the client would like to have the ability to simulate an external wave in a five-story building. The only option that came to my mind is to create specific lighting scenes and trigger them in a loop with certain time intervals.

Hello. I want to trigger multiple lighting scenes that repeat in a loop, but I dont know how to turn it off since the loop runs indefinitely. Disabling the scenes or using a “stop” command hasn’t been effective. Do you have any ideas on how to resolve this?

21 minutes ago, RAV said:

1. You can use Zone 2, set to fixed or 90%, use Composer to always turn on Zone2 to match living room.
2. You can use an HDMI de-embedder to get the audio between the TV and receiver.
3. You can use an HDMI de-embedder to get the audio from a source directly.
Send over Cat with baluns.

If you're after audio from streaming stuff, use a Roku or Apple or Shield rather than the TV and grab it from the add on box, option #3.

Thank you for reply!

1) How do I get out of the second zone? From output speakers? I am sending photos of the back of the amp.

2) I have ideas with extractor audio and converter stereo UTP. Will this solution work?

Thank you for help!
 

Hello,

Needs support to send audio from living room with local amplifiter to 2.0 triad audio system in other rooms. Below is the installation diagram.

Any ideas?

Thanks!

Hey. I have the problem with my EA1. After blackout of power in home my controller doesn't work. The LED on the front flashes red. Factory reset and network reset doesn't help. Any tips to bring him back to life?