DAlba
-
Posts
5 -
Joined
-
Last visited
DAlba's Achievements
-
This morning zigbee health is green. I did some testing and when I press doorbell the Z2IO driver Contact 1 Status changes from Open to Close and stays in closed state for 1 min and 40 sec before it resets to Open Status. I repeated procedure a few times. Is this normal or is there a way to shorten time for it to reset? My concern is someone may only wait 60 seconds before pressing doorbell again so I would never even get second notification...
-
Thanks. It is a lighted doorbell. I moved the z2io a little closer to controller and got it to -68 dBm but it's not doing anything now. I will try again tomorrow morning when attic is cooler
-
I do have chime in the mix. While I don't see any changes reflected in composer on z2io driver I went ahead and programed a light to come on when door bell is pressed. It works but weird thing is if I turn off the light in control 4 app and test doorbell button again but it doesn't turn the light back on. But if I wait like 10 minutes and press the doorbell button again the light comes on. What would cause such a delay from registering doorbell presses? I will also point out that zigbee signal strength of Z2IO shows only 1 bar so not sure if that could be issue. Zigbee Health shows RSSI -76 dBm
-
I added generic doorbell driver and bonded Contact Input 1. The Z2IO driver shows Contact 1 Status "Closed" while the other Inputs show "Open" When I press doorbell I don't see anything change though.
-
I currently have a regular doorbell connected to an ELK-930 doorbell detector which was connected to Insteon IO Link. I have since upgraded to Control 4 and would like to program some doorbell ring notifications/actions. I bought a C4-Z2IO and replaced the Insteon IO Link with it but I not sure if it's working or have it wired correctly. Do I even still need the ELK-930? I have included some pictures. I have Z2IO setup in Composer for IO Option 2: C1, C2, C3, C4 and its wired ELK-930 neg to Z2IO Cm and ELK-930 Out to Z2IO C1 When I press doorbell button I don't see any Contact 1 Status change in Composer Please advise
