browneye253 Posted October 14, 2016 Share Posted October 14, 2016 I have successfully setup the vera driver and I'm able to control a couple of zwave dimmers that were already installed. I'm now trying to control a switch but I don't see a driver for it listed w/ the vera stuff. I tried using the dimmer driver but it complains because the device isn't a dimmer. My work around is to create a scene in vera and then activate it but I was hoping to avoid the extra steps. Link to comment Share on other sites More sharing options...
skinner6695 Posted October 14, 2016 Share Posted October 14, 2016 Try the Z wave relay driver for the switch. I have it working on my vera plus on a zigbee plug switch. No scenes. Two-way communication. Link to comment Share on other sites More sharing options...
browneye253 Posted October 14, 2016 Author Share Posted October 14, 2016 Thanks for the suggestion. I'll give this a shot this evening. Link to comment Share on other sites More sharing options...
browneye253 Posted October 14, 2016 Author Share Posted October 14, 2016 That worked perfect for me. Thanks again for the help. Link to comment Share on other sites More sharing options...
mfg786 Posted November 6, 2016 Share Posted November 6, 2016 What to do with a motion sensor which is perfecting working on VERA PLUS In C4 I have used ZWave Security Sensor driver and see messages coming in from motion sensor, but when I connect it with generic motion sensor in C4 not working will appreciate help Link to comment Share on other sites More sharing options...
browneye253 Posted November 7, 2016 Author Share Posted November 7, 2016 I'm using zwave door sensors and motion sensors. Both of them I'm having to program against the state instead of using the open / close events. Link to comment Share on other sites More sharing options...
Tarcizo1 Posted April 24, 2017 Share Posted April 24, 2017 On 11/6/2016 at 7:39 AM, mfg786 said: What to do with a motion sensor which is perfecting working on VERA PLUS In C4 I have used ZWave Security Sensor driver and see messages coming in from motion sensor, but when I connect it with generic motion sensor in C4 not working will appreciate help Did you solve this issue? Thanks Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.