abovedeck Posted October 1, 2017 Share Posted October 1, 2017 i have several of these around the house and theyre all controlled by IR. All of them but ONE works perfectly. The box misses a lot of the IR commands. I've monitored the blaster and it sends out a signal every time, but it's like 3/5 times it hits. Does anyone know exactly where the IR sensor is for the mini 4k genie? THANKS. Link to comment Share on other sites More sharing options...
tekki70 Posted October 4, 2017 Share Posted October 4, 2017 Couple things to check Make sure it's wired correctly If its extended, stripe is on same extended wires, move eye a little bit, or just replace the emitter Would be my suggestion Link to comment Share on other sites More sharing options...
abovedeck Posted October 5, 2017 Author Share Posted October 5, 2017 On 10/4/2017 at 3:46 AM, tekki70 said: Couple things to check Make sure it's wired correctly If its extended, stripe is on same extended wires, move eye a little bit, or just replace the emitter Would be my suggestion thanks. not extended though and i've tried this with two other emitters, same issue. Link to comment Share on other sites More sharing options...
rolldog Posted April 19, 2018 Share Posted April 19, 2018 I realize this is an old post, but did you ever get this working? I'm in the same situation, and one of my clients just stopped responding to IR emitter after working fine for months. I'm considering changing back to the HR54 for IP control or just changing providers completely. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.