saluki2007 Posted November 14, 2018 Share Posted November 14, 2018 I just had my dealer install 3 zigbee i/o devices to act as thermostats for my radiant floor heat. He and I were under the impression there was a thermostat driver for these, he is now telling me there is not. I would like to being able to incrementally increase or decrease the temperature within my C4 app just like I would with my forced air. Right now the only way I have figured out how is to open up composer to do it. Any suggestions are greatly appreciated. Link to comment Share on other sites More sharing options...
lippavisual Posted November 14, 2018 Share Posted November 14, 2018 If your heat system is relay based, then the I/O is only going to tell it to turn on or off. There is no "set to this temp" available going this route. Better off putting in actual thermostats. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.