Jump to content
C4 Forums | Control4

GE Concord - Need help ASAP to exit system programming remotely


Recommended Posts

Well, I have a bad motion sensor that likes to go off when I'm away and my GE Concord is armed to AWAY.

So I logged into my Control4 system remotely with 4sight since I'm out of town and am stuck in the SYSTEM PROGRAMMING menu and cannot get out of it remotely.

Does anyone know how to exit the SYSTEM PROGRAMMING mode using Control4 remotely? or do I have to be using my actualy touchpad?

I need to rearm my system (all my light timers and obviously my security system are offline right now) and then bypass this sensor until I can delete it when I get home....

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...

Important Information

By using this site, you agree to our Terms of Use.