Jump to content
C4 Forums | Control4

Houselogix Honeywell Module


Bullseye

Recommended Posts

I replaced my Vista ICM with a HHIM.

I have programmed to receive a text message every time some doors are open. Now once I open the door and while the door is open I keep getting messages. I think it didnt happened with the ICM. How can I fix it?? Do I have to change programing??

Link to comment
Share on other sites


  • 2 weeks later...

Thanks!!

Have to try some different programing on the doors.

Now I have set messages when alarm set to Away Mode and when it goes Alarm State. I recive the message when set Away but not when goes to Alarm state. Should it be the first line in programming or any special order?

Thanks again!!

Link to comment
Share on other sites

I haven't tested the alarm state. I need to find a good time to set it off when the kids aren't around. They did release an update to the driver to fix the constant trigger of programming on zone open status when the zone is left open.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.