Jump to content
C4 Forums | Control4

Power cycling controllers


Recommended Posts

OK, with much hesitation I finally upgraded from 1.74 to 2.2. My first impressions are very positive.

Now for the million dollar question...I now use RA2 lighting control instead of C4 and am thinking on using some lutron appliance modules to weekly power cycle my controllers through the RA2 software. It would take 6 appliance modules (1 for each controller) and set them on a lutron schedule to be ON, but once a week to turn OFF in the middle of the night for 5 min. Just to power cycle the controllers. A forced reboot if you will.

Just to make sure nothing gets bogged down.


Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...

Important Information

By using this site, you agree to our Terms of Use.