hevnbnd Posted December 31, 2012 Share Posted December 31, 2012 I have a new Honeywell Vista20P Rev 9.12 with CBM432 module. I have read everything I can find on these via google and c4 forums. What I have learned.-Control4 Driver Documentation is WRONG. It calls for a straight cable and everything I have read says to use a NULL/Crossover Cable. I currently have Ground wired to pin5, RX wired to Pin3, & TX wired to Pin2-Panel programming shows:*91 Option Selection: 08 (Enable Exit delay restart/reset), 02 (Enable RIS)*189 AUI Device Enable: 1, 1, 5 (Remote Services Partition 1), 5 (Remote Services Partition 1)-All I get is a rapidly flashing LED on the CBM432 Module. Does not matter how many times I hit reconnect.What I am not sure of.-How do I setup the ECP address for 1st VIRTUAL Keypad on the Honeywell Panel? Was not sure how to set it to 1,2,3,4 or 5..Any help would be great I am out of ideas. Thank you very much! Link to comment Share on other sites More sharing options...
avittech Posted December 31, 2012 Share Posted December 31, 2012 Honeywell 4232CBM Settings1. Program Panel *91 02 (none, RIS enabled)2. Program Panel *189 5000 (AUI 1 5 = part. 1 (auto-stay arm disabled))3. Wire TX from C4 to RX on 4232CBM RX to TX5. Reboot CBM (unplug 4 pin connector, reconnect)6. Reconnect C4 Panel through virtual keypad Link to comment Share on other sites More sharing options...
hevnbnd Posted December 31, 2012 Author Share Posted December 31, 2012 Ok I changed the program and double checked my wiring. Still same result... No Communication! Link to comment Share on other sites More sharing options...
avittech Posted January 1, 2013 Share Posted January 1, 2013 Do you ha e any touchscreen Honeywell keypads or are you using total connect? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.