Chrus101 Posted May 18, 2014 Share Posted May 18, 2014 Suspect the following problem has been caused by putting all my electronic devices associated with my control4 system on a timer to automatically switch it off at night & on again first thing in the morning. When I try to use the remote control or iPad control4 software it gets stuck trying to connect. Tried the standard things, turn on & off as well as the hard reset suggested in the user manual. When i do a hard reset the power led comes up solid blue and the wifi led starts flashing yellow/orange followed by flashing blue & after about a minute no light. Left with just the power led (solid blue) any ideas will be greatly appreciated. cheers chris Link to comment Share on other sites More sharing options...
mstafford388 Posted May 18, 2014 Share Posted May 18, 2014 my first idea would be to not hard reboot your devices every night. it sounds like you just did a factory reset, so you just cleared the controller of your project, leaving nothing for your remotes and ipads to connect to. I'd call a dealer. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.