Using HC-800 with AMP108

[davededo]

Hi All,

These forums are such a great community of people helping each other. 

Hoping someone can assist with the following question. Is it possible to send audio signals from the HC-800 to the C4-AMP108 without a matrix switch in between if I am only using two audio sources?

Thanks 

[mujtaba.khokhar]

It depends...

Doesn't matter how many audio sources you are using, what matters is how many rooms you are going to with the amp. if its just 2 rooms then yeah it will work. if more rooms then you need an audio matrix. 

Thanks 

M

[davededo]

Thanks so much for the response. Will be going to 6 rooms so will therefore need an audio matrix. Out of curiosity, what would I need to do to get it working for only two rooms in the interim?

[davededo]

29 minutes ago, mujtaba.khokhar said:

It depends...

Doesn't matter how many audio sources you are using, what matters is how many rooms you are going to with the amp. if its just 2 rooms then yeah it will work. if more rooms then you need an audio matrix. 

Thanks 

M

Thanks so much for the response. Will be going to 6 rooms so will therefore need an audio matrix. Out of curiosity, what would I need to do to get it working for only two rooms in the interim?

[mujtaba.khokhar]

audio output from HC 800 to input on amp.

set your bindings for volume and audio to the output of hc800 

refresh navs 

Let me know if you need a hand programming it 

Thanks 

M