HEAT Posted May 30, 2006 Posted May 30, 2006 Hi Guys, We are a new C4 dealer and we're really excited with what we have already been able to do with the systems. We would like to create a wake up scene for the master bedroom that will flash the light and play an MP3 playlist through the speaker point. Here is the hard part - we want the extra button on the LCD Keypad to function as a snooze and off button. When the button is pressed, the scene should stop for 8 minutes then start again, unless at any time after the initial wake up scene has started, the button is held for three seconds to turn off the scene and leave the light on. Should be simple enough, right? Any programming help from the gurus out there on this whole mess would be greatly appreciated!
mrpugh Posted September 10, 2007 Posted September 10, 2007 Its possible with one little change. Instead of holding for 3 seconds, a double-click to end the alarm? If thats ok then here goes.In agents: Create a variable (number) called snoozeIn programming: When "Room"-> LCD Keypad button is pressedVariables-> Snooze = Variables-> Snooze +1When "Room"-> LCD Keypad button is releasedWait 1 secondIf Variables-> Snooze EQUAL to 1 Room off Light off Delay 8 minutes Execute wakeup (Name) in Bedroom1If Variables->Snooze EQUAL to 2 Room off Light onVariables->Snooze=0When wakeup scene (Name) executeslight onwait 1 secondlight offwait 1 secondlight onwait 1 secondlight offwait 1 secondlight onwait 1 secondlight offwait 1 secondlight onwait 1 secondlight offwait 1 second(repeat as necessary)light on (light will stay on if alarm is on for x amount of seconds.Hope this helps
RyanE Posted September 10, 2007 Posted September 10, 2007 HEAT,I would also suggest that you post this on the Control4 Dealer Forums (forums.control4.com), as not too many dealers or Control4 employees read the 'external' forums.RyanE
Recommended Posts
Archived
This topic is now archived and is closed to further replies.