swassbac
-
Posts
17 -
Joined
-
Last visited
Content Type
Profiles
Forums
Blogs
Gallery
Downloads
Events
Posts posted by swassbac
-
-
I know this is an old thread but I thought I'd try and see if any of you have a suggestion. In the past, I never had any luck with a stereo 1/8" patch cable and the only way I was able to pass the IR from the C4 controller to an HDBaseT sender (using the Accell units - https://www.amazon.com/Accell-E090C-003B-UltraCat-Single-Extender/dp/B0058M3RW8/ref=cm_cr_arp_d_product_top?ie=UTF8) was to attach an emitter to the EA5 output and then attach an IR receiver to the HDBaseT sender. I tape the two together and it has worked reliably but always to be a hack.
I am updating some things in my rack and thought it would be nice to clean those up but I haven't been able to figure out a way to from the C4 mono IR output to what I assume is a stereo IR input on the Accell units. I've tried a mono to stereo adapter and a binary 12V adapter that says it "removes 12VDC for IR connection to control system" with no luck.
Any ideas?
-
-
On 2/5/2020 at 6:30 PM, cdepaola said:
Biggest downfall, as with several other similar systems is many wont with with pipes larger then 1" and outs is 1.5".
What did you ever decide on? I also have 1.5" service so have limited options. Did you confirm LeakSmart had flow detection in addition to sensors?
Ecobbee disconnect problems
in General Control4 Discussion
Posted
Did anyone ever find a permanent resolution for this? I get the "disconnected from network" every couple of days even without an EA5 reboot. Has gotten worse lately - I have it trigger a text when the connection is lost so I know to change a setting to get it to reconnect but it is super annoying.