cannemi Posted May 1, 2012 Share Posted May 1, 2012 Hey Guys, I just got started with HE and I am trying to figure this programming out. Currently I have a 6 button keypad in the living room and one of the button's I am going to label watch tv. So I need to turn on the Denon Receiver, Turn on Directv, Turn on samsung tv, and set Denon to SAT/CBL. This is what I have so far but the denon IR isn't triggering to turn on unit. Suggestions? I am also trying to take it one step further and have the light change to red. Thanks Link to comment Share on other sites More sharing options...
ILoveC4 Posted May 1, 2012 Share Posted May 1, 2012 You don't program it that way. Just select whatever media source you want in that room and it will auto-magically turn all the right stuff on for you (if the bindings were setup correctly). Link to comment Share on other sites More sharing options...
cannemi Posted May 1, 2012 Author Share Posted May 1, 2012 Not sure if I am following. How does it know what to do when Button 5 is pressed. As of now doesn't it need an action to perform. I was wonder, there has to be a simpler way. Should I not be configuring under programming? Link to comment Share on other sites More sharing options...
cannemi Posted May 1, 2012 Author Share Posted May 1, 2012 I got it!!! Wow I was way over thinking that. Took me about 4 reads of thread but I got it... Thanks Link to comment Share on other sites More sharing options...
ILoveC4 Posted May 1, 2012 Share Posted May 1, 2012 Everything on the left is correct, but on the right side select the room, then below select the media source.Done.Make sure you clear out what you have there.Edit: you apparently figured it out before my post. Good work! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.