abeasst Posted March 3, 2013 Share Posted March 3, 2013 I am getting an error "System Event Output Off" on my control4 for my Concord4 security system. I wanted to know if anyone knows how to resolve this issue so I will stop getting push notifications from my control4 system. Link to comment Share on other sites More sharing options...
abeasst Posted March 5, 2013 Author Share Posted March 5, 2013 any ideas? Link to comment Share on other sites More sharing options...
Cyknight Posted March 5, 2013 Share Posted March 5, 2013 Hmm are you on 2.3 and if so has the security patch been applied? If yes and no, then you may need to get your dealer to do this, will likely fix this. Link to comment Share on other sites More sharing options...
abeasst Posted March 5, 2013 Author Share Posted March 5, 2013 I'm on 2.2.4. Link to comment Share on other sites More sharing options...
abeasst Posted August 7, 2013 Author Share Posted August 7, 2013 bump any other ideas? Link to comment Share on other sites More sharing options...
Godzilla Posted August 8, 2013 Share Posted August 8, 2013 1st thing is........is your alarm system working without control4, by itself Link to comment Share on other sites More sharing options...
abeasst Posted August 8, 2013 Author Share Posted August 8, 2013 Yes. It will beep to indicate that the home automation module isn't getting a signal, but I can arm, disarm, etc the system from the keypad no issue. Link to comment Share on other sites More sharing options...
Cyknight Posted August 8, 2013 Share Posted August 8, 2013 So are you seeing an Bus failure on your security keypads? Link to comment Share on other sites More sharing options...
abeasst Posted August 8, 2013 Author Share Posted August 8, 2013 Only if I disconnect the RS232 cable from the control4 otherwise I get no messages on the keypads. I just see the above message listed in navigator when I go to the alarm screen. Link to comment Share on other sites More sharing options...
Cyknight Posted August 8, 2013 Share Posted August 8, 2013 And when connected you do not get the error on the "normal" security keypads, correct? Only on the C4 interfaces? Just trying to get as much info as I can. Link to comment Share on other sites More sharing options...
Cyknight Posted August 8, 2013 Share Posted August 8, 2013 Did some digging - seems this should be cleared on Concord 4 on 2.3, in some cases 2.4 or higher fixed it.I'm guessing this usually comes up a short while AFTER arming or disarming the system? Link to comment Share on other sites More sharing options...
abeasst Posted August 8, 2013 Author Share Posted August 8, 2013 Correct no errors on keypads when connected and it only shows on the C4 interface. It comes up a short period after clearing it without any arming or disarming. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.