Baubas Cat Posted July 18, 2014 Share Posted July 18, 2014 How do you change the zigbee server ip address? Link to comment Share on other sites More sharing options...
mstafford388 Posted July 18, 2014 Share Posted July 18, 2014 Your zigbee server sits on a controller. you would change that controllers ip address through system manager. Link to comment Share on other sites More sharing options...
Baubas Cat Posted July 18, 2014 Author Share Posted July 18, 2014 I can change the controllers ip address but the zigbee address stays the same. The result is no zigbee control. How do I change the zigbee server address to match the controllers address? Link to comment Share on other sites More sharing options...
wingzz Posted July 21, 2014 Share Posted July 21, 2014 in composer you can set the Zigbee channel for the HC's, for remotes and light switches it is done via key presses.What device are you trying to change the zigbee channel on?? Link to comment Share on other sites More sharing options...
mstafford388 Posted July 21, 2014 Share Posted July 21, 2014 The zigbee servers IP address should automatically match that of the controller. Does it not match? Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
Baubas Cat Posted July 21, 2014 Author Share Posted July 21, 2014 It's an HC-500. If I delete it from the project and then add it back in it gets a new IP address but if my router goes wonky and gives it a new IP address the zigbee server stays on the old address. I just wanted to know if there was a way to change the zigbee server address without deleting the controller. Link to comment Share on other sites More sharing options...
mstafford388 Posted July 21, 2014 Share Posted July 21, 2014 I've honestly never seen that happen before, although the HC-500 is a dinosaur at this point. Would setting the HC500 to a static ip address so it doesn't change solve your issue? have you tried that? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.