Jump to content
C4 Forums | Control4

Return LED behavior to normal


Recommended Posts

I have programmed the LEDs on switches near outside doors to both be red when the security system is armed. I've not found a good way to put the LEDs back into a "normal" state (top on with light on, etc) when the system is disarmed - is there a quick way to restore the switch default?


Composer HE 2.6.0





Link to comment
Share on other sites

As that thread says....if you program it based on the state being armed, program the LED colors when the alarm state is not on.  For me, my alarm state for being home is either Stay (motion sensor off) or Away (motion sensor on) and Disarm (no alarm) or Alarm which means the alarm is going off.  So for Stay/Away i programmed LED's to be red on the bottom, etc and for Disarm I programmed it without Red LEDs.  

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...

Important Information

By using this site, you agree to our Terms of Use.