RobbieF Posted September 17, 2018 Share Posted September 17, 2018 After some advice here..... I have a new sliding door being installed, and the lock for the door is a 12V actuator. The supplier is planning on installing a "Niko" switch (Effectively the same as a C4 Keypad Switch, but some German brand or something), which toggles the Supply to a 12V 2.5A Regulator, which then goes to the lock actuator. Obviously I want everything C4, so plan on swopping out the Niko switch for a C4 one, but have one question..... Can you have the "Light" load show up as a lock (Which it is in this case), instead of a light? And could I use a Panelised Lighting relay circuit in the same manner (Instead of the C4 switch keypad)? Thanks in advance! Link to comment Share on other sites More sharing options...
sonic30101 Posted September 17, 2018 Share Posted September 17, 2018 Chowmain has a relay to light driver that you can bind a generic door driver to so it shows up in the motorization section, you can also use experience buttons or the blackwire emoji driver to do a door icon on any page Link to comment Share on other sites More sharing options...
RobbieF Posted September 18, 2018 Author Share Posted September 18, 2018 Thank you @sonic30101! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.