Brad Beam Posted July 16, 2009 Share Posted July 16, 2009 I have an issue with a tv in my master bath. The video signal cuts in and out. It is fed through an 8x8 shinbow switch. The audio goes unitterupted. Any ideas? Link to comment Share on other sites More sharing options...
thecodeman Posted July 16, 2009 Share Posted July 16, 2009 Bad cables ? Bad input on the tv? Bad output on your matrix switch? Link to comment Share on other sites More sharing options...
Brad Beam Posted July 17, 2009 Author Share Posted July 17, 2009 video from the 777 works fine Link to comment Share on other sites More sharing options...
lippavisual Posted July 17, 2009 Share Posted July 17, 2009 Then what source is cutting out? I'm guessing a cable box. If that's the case, ou probaby don't have enough signal to the RF input on the box. Link to comment Share on other sites More sharing options...
Brad Beam Posted July 17, 2009 Author Share Posted July 17, 2009 The direct tv signal cuts out. This tv is apporx the same distance as the master bed tv. I don't have any prob with the master bed Link to comment Share on other sites More sharing options...
thecodeman Posted July 17, 2009 Share Posted July 17, 2009 This is going to be one of those quirks where someone really needs to be onsite to check it out. Link to comment Share on other sites More sharing options...
Brad Beam Posted July 17, 2009 Author Share Posted July 17, 2009 i was afraid you were going to say that Link to comment Share on other sites More sharing options...
Mav-Jason Posted July 18, 2009 Share Posted July 18, 2009 If you're willing, you could swap the cables from the bedroom and bathroom on the switch, and see if the prob is then on your bedroom tv to narrow it down. Link to comment Share on other sites More sharing options...
AS2 Posted July 20, 2009 Share Posted July 20, 2009 This sounds like it could be resolution. Is that a really small TV? try feeding it 720p or even 480p to check Link to comment Share on other sites More sharing options...
Brad Beam Posted July 20, 2009 Author Share Posted July 20, 2009 I switched the reciever to 720p and the tv flashes increased. I think the tv is set to 1080i but im not sure i cant find the manual Link to comment Share on other sites More sharing options...
pharmdsmith Posted July 20, 2009 Share Posted July 20, 2009 I just had a similar issue but it was a pixilated picture. It wound up being the balun. The 777 looked good because it was 480 whereas the other video sources were messed up. Link to comment Share on other sites More sharing options...
Brad Beam Posted July 21, 2009 Author Share Posted July 21, 2009 video is all component Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.