crazzyrah Posted January 5, 2010 Share Posted January 5, 2010 so i finaly got around to hooking up the HC200 for my first room! it worked it was identified and everything but then when it came time to sync the remote no go! the remote keeps saying no network found any ideas?Thanks! Link to comment Share on other sites More sharing options...
ILoveC4 Posted January 5, 2010 Share Posted January 5, 2010 It sounds like you haven't ever properly added it to the project... Link to comment Share on other sites More sharing options...
thecodeman Posted January 5, 2010 Share Posted January 5, 2010 http://c4forums.com/viewtopic.php?pid=35323#p35323 Link to comment Share on other sites More sharing options...
crazzyrah Posted January 5, 2010 Author Share Posted January 5, 2010 it wont let me identify it due to it not being on a network? Link to comment Share on other sites More sharing options...
ILoveC4 Posted January 5, 2010 Share Posted January 5, 2010 Due to the reason I stated above. Link to comment Share on other sites More sharing options...
crazzyrah Posted January 5, 2010 Author Share Posted January 5, 2010 gotya, the remote simply says "control4 remote" if i do the manual reset with holding the 0 and "4" after reinserting a battery it says no network found is there a way to change the channel on the remote to match the one on my director? Link to comment Share on other sites More sharing options...
ILoveC4 Posted January 5, 2010 Share Posted January 5, 2010 You don't need to change the channel, you need it added to your project in order for it to be identified. I'm not going to continue repeating myself. Good luck. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.