prahz2000 Posted January 29, 2010 Share Posted January 29, 2010 Hi,My SR 250 does not identify during the interview process (press red 4 button 4 times). I've tried holding down the 0 and red 4 button to reboot but still the same issue. I've also tried the 2, 4, 8, 6, #, * method to match the Zigbee channel to channel 14.Any help would be greatly appreciated. I am using an HC-300 in a very small one-room setup.Paul Link to comment Share on other sites More sharing options...
thecodeman Posted January 29, 2010 Share Posted January 29, 2010 Why are you using the interview process? Last I checked that hasn't been updated in some time and may not reflect the SR250. Link to comment Share on other sites More sharing options...
prahz2000 Posted January 29, 2010 Author Share Posted January 29, 2010 I've tried manually identifying as well. When I press the Red 4 button 4x it does not identify. Link to comment Share on other sites More sharing options...
thecodeman Posted January 29, 2010 Share Posted January 29, 2010 What did tech support say? Link to comment Share on other sites More sharing options...
prahz2000 Posted January 31, 2010 Author Share Posted January 31, 2010 For anyone else who has had the same problem (and I've seen a few other posts on this same topic)...try pressing the red 4 button 4 times but faster. I was simply going too slow. Link to comment Share on other sites More sharing options...
takitezsdc Posted January 31, 2010 Share Posted January 31, 2010 Take the remote outta your system and then add the driver back in......make sure you use the correct driver.Then try dentifying it again in the connections tab. I had the same problem and had to reload the driver. Link to comment Share on other sites More sharing options...
ILoveC4 Posted January 31, 2010 Share Posted January 31, 2010 In the post directly above yours he said he got it working. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.