Big_D73 Posted November 14, 2011 Share Posted November 14, 2011 I have an older dimmer (was running 1.8 or 2.0, not sure which anymore) that when powered up, even with no load present, just sits and blinks a rapid red, white, blue, then about a 2 second pause, and flashes again, and continues this vicious cycle. I had removed it from the system, and now it won't re-identify (either in Zigbee or Embernet modes), and the only button press sequence that seems to do anything is holding the bottom button for 4-5 seconds, which causes a very rapid purple-ish flashing for about a half a minute, and then goes back to the red, white, blue flashing... I'm assuming it's just DOA, but looking for any suggestions....? Link to comment Share on other sites More sharing options...
chesterwilson Posted November 14, 2011 Share Posted November 14, 2011 DOARed/White/Blue is the kiss of death Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.