drmark12pa Posted January 16, 2012 Share Posted January 16, 2012 I just installed a 2 previously used Control4 dimmers (will be integrated tomorrow by my dealer).Bedroom 1---When I hit the top button, the bedroom light turns on to about 75% brightness. I can tap on the top button and ramp up to 100%.When I hit the bottom, it ramps down to off normally.Bedroom 2--No LEDs are on but the dimmer works perfectly. When I pull up on the "reset tab" the LEDs flash different colors and turn off.I've not seen these issues with a dimmer before when I've installed before integration. Are these issues normal or is something wrong? I'm sure once integrated I can just say when top button pressed it ramps up to 100% on the one but just want it to work should my Control4 system be offline for whatever reason as well... Link to comment Share on other sites More sharing options...
thecodeman Posted January 16, 2012 Share Posted January 16, 2012 Check Dimmer properties in sys design. Link to comment Share on other sites More sharing options...
drmark12pa Posted January 16, 2012 Author Share Posted January 16, 2012 Actually just did a 9-9-9 tap on the both of them and both work perfectly now without being integrated.... Link to comment Share on other sites More sharing options...
thecodeman Posted January 16, 2012 Share Posted January 16, 2012 Actually just did a 9-9-9 tap on the both of them and both work perfectly now without being integrated....A factory reset will do the trick, certainly. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.