hi,
I tried using it, but the input seemed to randomly roll based on what the original input is. so for example, I have the ATV connected to the rear HDMI on the oppo, and the oppo has a HDMI run to the projector and the 2nd HDMI out is used for the audio which runs to my current receiver.
in composer, I have the binding from the oppo output linked to both the receiver and HDMI2 on the projector, and the out from the ATV is linked to the HDMI in on the oppo inputs.
the system defaults on any 'on' command to directv (run from dvr to rec to HDMI1 on proj through rec).
when I change the input to OPPO, the video on the proj. changes to HDMI2, but the input on the OPPO will either change to BLURAY (if the last thing watched was ATV) or to ATV (if the last thing watched was BLURAY). the same thing will happen when I select ATV, it will roll to the nect input, and does not seem to be able to select the correct one.
using the IR driver I am able to send a 'input' then '2' when selecting ATV, and this seems to work fine every time.
I am also selecting input 'bluray" on the ir driver for OPPO selection,a d this seems to change it to the correct input.
I didnt see these control options available on the IP driver, unless there is a newer version of which I am unaware.