jgmass1

Thanks for the replies so far.  Problem started several months back - but has gotten progressively worse.  A re-boot of the entire network helps for ~1 day, but then comes back with increasing frequency.  There were some changes: addition of the Zwave module to control two Zwave outlets plus a 2nd SR260 remote; A new Wifi AP (Ubiquiti) for the network

I'll check the CPU usage tonight.

Thanks again

Need some guidance on where to start to debug an erratic system.

Symptom: Significant lag time (20 to 30s) in system response to a SR260 remote command (pwr on or off; channel up/down; vol up/down; etc), as well as Alexa voice command, and a scheduled macro. 

System: 1 EA3 and 1 EA1; EA3 is in Master Bedroom; EA1 in Family room;  Have Caseta lighting integrated (20+devices) + Vera Plus with motion sensors + Alexa units in various rooms + C4 Zwave module.  House has multiple WiFi AP's for coverage 

I am thinking network issues, but also could be radio interference.

Any thoughts/direction is appreciated

So - I added the Vera ZWave security sensor driver, and it is bound to the Vera Controller.  The ZWave security sensor is connected to the generic motion sensor.  When I run my hand over the actual sensor - I can see a change of state to closed (verified = Yes).  So it seems to be working.

Under programming:

When the Motion sensor senses motion: If specific light is off, then turn on that light 

When the Motion sensor stops sensing motion: If specific light is off, then turn off that light

When I hit the execute button for each script, they each execute.

I have many other events tied to similar logic - just cannot seem to have the motion sensor trigger simply turning on a light

Trying to integrate Veraplus into C4.  Have the Vera driver connected - "Vera connection successful - Full device data downloaded.  I then loaded a generic motion sensor.

Under properties of the Zwave controller, I have the zwave management link listed under inputs - but there are no sensors to bind to.

Some questions:

1. Where will I see the devices in Vera? 

2. How do I bind the motion sensors to Vera?

Thanks in advance