browneye253 Posted March 13, 2019 Share Posted March 13, 2019 I've got an HC-250 that isn't mounting the SD Card. I've attempted to reseat the card and swap it with a different one. The one I swapped with is a 32GB instead of the 8GB size that is in there. Any tips or steps I could try to get it to recognize the card or am I looking at a bigger problem? The plan was to use it to run a small living room setup. Would I still be able to do that without the SD card or am I asking for trouble? Link to comment Share on other sites More sharing options...
lippavisual Posted March 13, 2019 Share Posted March 13, 2019 It needs the SD card. Have you tried a smaller size?? 32GB is a little excessive, IMO. Anytime I've swapped them, 16GB was the max size I'd put in. I'm not even sure if the size makes a difference at all, but wouldn't be surprised if it did. Link to comment Share on other sites More sharing options...
browneye253 Posted March 14, 2019 Author Share Posted March 14, 2019 32GB was the only spare I had on hand. I found a dead 250 and pulled its card which was a 4GB and threw it into the box and it mounted just fine. I was able to clear the project and get the new one setup. So far the swapped card seems to be doing the trick. I think I read a KB article after the fact that 16GB was the max size. Thanks for the tip on the smaller size. Link to comment Share on other sites More sharing options...
lippavisual Posted March 14, 2019 Share Posted March 14, 2019 Glad it worked. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.