Teammac Posted September 10, 2020 Share Posted September 10, 2020 Hello. I've searched online and haven't found this particular issue so looking for some help. I installed a Honeywell Vista 21IP with a 4232CBM. C4 is on OS3. Everything connected fine and C4 sees the alarm system, arm, disarm, status, all work fine. Within the alarm system, wired motion sensors work fine however, they do not respond in C4. The motions appear in UI (Person walking) but don't show motion when tripped. I added generic motion sensors and made the connections, still don't activate. Any ideas or help? Thanks Quote Link to comment Share on other sites More sharing options...
msgreenf Posted September 10, 2020 Share Posted September 10, 2020 use that in my house and it works. Do you have the zone type set properly? Quote Link to comment Share on other sites More sharing options...
Teammac Posted September 10, 2020 Author Share Posted September 10, 2020 I have the zones set as (04) Interior Follow , Partition 1, Report Code 20, normally closed. Various names ie, "Family Room Motion". Quote Link to comment Share on other sites More sharing options...
msgreenf Posted September 10, 2020 Share Posted September 10, 2020 but did you have it set in the driver as zone type? Quote Link to comment Share on other sites More sharing options...
Teammac Posted September 10, 2020 Author Share Posted September 10, 2020 Yes. In the driver, under Security Panel, Partition 1, the zones auto populated. The motions are listed as "motion sensors". "State" box is checked, "Can Control" is not checked. Quote Link to comment Share on other sites More sharing options...
msgreenf Posted September 10, 2020 Share Posted September 10, 2020 yeah, that should work.. Quote Link to comment Share on other sites More sharing options...
Teammac Posted September 10, 2020 Author Share Posted September 10, 2020 Just installed a wired basic contact sensor. Installed and connected drivers, sensors don't respond in C4. If I close the sensor the system shows ready in C4, open it and system immediately changes to "not ready to arm" but nothing for the sensor itself. Quote Link to comment Share on other sites More sharing options...
Teammac Posted September 11, 2020 Author Share Posted September 11, 2020 Got it working. RIS Mode *91 on panel set to "8, 2". Read a lot of instructions stating newer panels don't need programming for RIS Mode. Tried it on my Vista 21ip and bingo! Posting in case anyone else runs into this issue. msgreenf 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.