JEC Posted January 15, 2017 Share Posted January 15, 2017 I setup an experience button that starts the beep on my 260 remote and then stops the beep when selected again. At present, I only have one instance of the UI button.... I would like to use this single instance to trigger the beep for a remote based on the room where the button was pressed... For example, IF UI button pressed (activated) in living room, start living room remote beep ELSE IF UI button pressed (activated) in bedroom, start bedroom remote beep Is this possible? Or am I over complicating things and should have a separate UI button instance in each room that directly corresponds to a single remote? Thanks! Link to comment Share on other sites More sharing options...
eddy.trochez Posted January 15, 2017 Share Posted January 15, 2017 You need one button per room, then hide the others in every room. Link to comment Share on other sites More sharing options...
vitali Posted January 16, 2017 Share Posted January 16, 2017 I do it almost for every project. you can do custom button for each remote and apply for each room or you can do scroll menu with buttons and make it visible in every room. some small problem, you can do only 6 buttons (6 remotes attached) for one scroll down menu. Link to comment Share on other sites More sharing options...
JEC Posted January 16, 2017 Author Share Posted January 16, 2017 Thanks figured... but wanted to check if I wasn't missing some variable that I could use to tell from what room someone selected the UI button.... Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.