Kobepanda

Hi Jackstone, Do you have a download link for the version 1.5?

Hi Jackstone, In your previous post, you suggested to try with the version 1.5 Baudrate Changer, because for some reason the 2.0 version is not being able to detect the DMX engine after binding the Baudrate Driver to a serial port on Controller in C4 Composer. However, I couldn't find the download link for the 1.5 version. Can you provide some detail instructions to solve this driver/baudrate problem?

Hi Jackstone, Where can I download the 1.5.x baudrate Changer? What are the commands for using Putty to change the baudrate?

Thank you Jackstone for the recommendation. What software can be used to change the band rate if 1.5.9 driver doesn't work?

Hi Jackstone, I am trying to integrate the RS-232 Driven DMX Engine from Engineering Solutions Inc. to Control4 with the Advanced DMX V2 for Control4 Driver. However, the Status of the RS232 DMX Engine Driver is showing the message "Timeout getting Firmware. check DMX Engine connection.". Equipment: 1 x RS-232 DMX Engine 1 x Serial to 3.5 mm cable 1 x Control4 EA-5 Controller 1 x Advanced DMX V2 for Control4 License Setup: The DMX Engine is connected to a EA-5 Controller with the Serial to 3.5 mm cable. The serial side of the cable is connected to the serial port on the DMX Engine and the 3.5 mm side is plugged into the IR 1 (Serial 3) port on the EA-5 Controller. The License key is applied to the RS-232 DMX Engine Driver (V.2.02) in Control4. I followed the instruction in the firmware update zip file to update the DMX Engine firmware, and it seems, not for certain, the firmware was updated successful. However, when I connect it to Control4 for updating the Band rate with DMX Engine Baudrate Changer Driver, the information property in the driver doesn't display "Device Online" after binding the driver to a serial port. It seems like the Control4 system is not able to communicated with the DMX Engine. What can I do to check the firmware version? Can you recommend some solutions that I should try with this problem?