dbuono Posted July 19, 2012 Share Posted July 19, 2012 Has anyone installed one of these matrix switches? If so, how does it work in conjunction with C4?http://www.gefen.com/gefentoolbox/gtbproduct.jsp?prod_id=10306Thanks Link to comment Share on other sites More sharing options...
chesterwilson Posted July 19, 2012 Share Posted July 19, 2012 No but it is quite inexpensive ($1600). Id personally go with the snap non cat5 unit, if you can get it at asimilar price. Link to comment Share on other sites More sharing options...
cdepaola Posted July 19, 2012 Share Posted July 19, 2012 It should work fine assuming there is a driver or your installer can write a driver. Gefen is obviously a well known pro level brand and the toolbox series is excellent for difficult or unusual installs. Link to comment Share on other sites More sharing options...
AJ_ Posted July 19, 2012 Share Posted July 19, 2012 Wow! For $1600, this is not bad at all. I have a Monoprice 4x4 now but I'll go with this one when I upgrade. It has a serial port and the spec states RS-232 support for automation so it should work. Worst case, it does have IR. Link to comment Share on other sites More sharing options...
fredpenner Posted August 14, 2012 Share Posted August 14, 2012 Am I missing something or is this finally the end of the 5k+ 8x8 switches?? Anyone have any experience with these? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.