wingzz Posted February 14, 2013 Share Posted February 14, 2013 I was looking for any white paper or instructions on adding a BL-30 camera to my project, does such a thing exist?Also I see in the drivers 1 called PTZ and 1 that was just pan and tilt, I'm assuming I would use the pan and tilt driver, is that correct? Link to comment Share on other sites More sharing options...
RyanE Posted February 15, 2013 Share Posted February 15, 2013 Yes.RyanE Link to comment Share on other sites More sharing options...
wingzz Posted February 15, 2013 Author Share Posted February 15, 2013 Ok I can see the camera in the navigators and can control the camera as far as pan and tilt but I am not getting am image in navigators, what can I check that I'm might be doing wrong Link to comment Share on other sites More sharing options...
wingzz Posted February 16, 2013 Author Share Posted February 16, 2013 Any ideas here, I cant get an image to show up on the TS.when I test the connection in the driver it shows good but still no image?? Link to comment Share on other sites More sharing options...
wingzz Posted February 18, 2013 Author Share Posted February 18, 2013 Ok I get a moving image on my 7" wall mount but not on the 7" portable or the 3.8" Please help Link to comment Share on other sites More sharing options...
wingzz Posted February 19, 2013 Author Share Posted February 19, 2013 any one here can offer any help with this?? Link to comment Share on other sites More sharing options...
ILoveC4 Posted February 19, 2013 Share Posted February 19, 2013 Are the touchpanels properly identified via UUID, or are they identified via IP. Link to comment Share on other sites More sharing options...
wingzz Posted February 19, 2013 Author Share Posted February 19, 2013 Are the touchpanels properly identified via UUID, or are they identified via IP.I'll have to check that tonight, will get back to you on that.Is one preferred over the other?? Link to comment Share on other sites More sharing options...
thecodeman Posted February 19, 2013 Share Posted February 19, 2013 Uuid generally, this would mean broadcast traffic is working well. Link to comment Share on other sites More sharing options...
ILoveC4 Posted February 19, 2013 Share Posted February 19, 2013 Obviously thecodeman is right. I had some devices identified via UUID a while back, and it caused some funky stuff to take place. Look at everything...controllers, etc... and make sure they're all via UUID. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.