Baubas Cat Posted November 28, 2014 Share Posted November 28, 2014 All the lights are green and when I try to identify it they all turn red and flash about 10 times then go back to green. I've tried leaving the mesh and rejoining but I get the same results. It excepts all button presses except for the channel sequence (7-4-7). I can't check what channel its on. It was in the system but was very unreliable. It would only execute commands 40% of the time. I thought if I removed it and put it back in, it might work better but now I can't get it to rejoin. Any suggestions? Link to comment Share on other sites More sharing options...
Baubas Cat Posted November 28, 2014 Author Share Posted November 28, 2014 I put composer in auto join and now it goes from green to yellow then flashes red. Link to comment Share on other sites More sharing options...
mstafford388 Posted November 28, 2014 Share Posted November 28, 2014 What's your mesh like? the fact that it was sometimes working makes me think you may have a signal strength issue. Link to comment Share on other sites More sharing options...
Baubas Cat Posted November 28, 2014 Author Share Posted November 28, 2014 Got it to identify on channel 11. Previously I was running the system on 25. I thought 25 was suppose to have less interference but if it continues to work on 11, I see no point in switching channels. Link to comment Share on other sites More sharing options...
prabeau Posted November 29, 2014 Share Posted November 29, 2014 Would somebody tell me how to do this I'm also an "end user" and can't find anywhere in Composer to make these adjustments ! Link to comment Share on other sites More sharing options...
dogdvr Posted November 30, 2014 Share Posted November 30, 2014 Is Baubas also a end user? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.