earo Posted October 22, 2016 Share Posted October 22, 2016 I need some help w/ my JAP setup to update the firmware and reset the EDIDs. I am unable to pass through the 5.1 from the transmitters to the receivers reliably. I'm a very knowledgeable end user and can have two networks setup -- one to the internet and one to the switch to facilitate remote troubleshooting. Rough set up: Dedicated Cisco SG300 switch, isolated from the rest of my network 4 2G transmitters (3 DVRs, 1 Apple TV4) 4 2G receivers 1 2G+ receiver Link to comment Share on other sites More sharing options...
GoBigBlue Posted October 23, 2016 Share Posted October 23, 2016 I suggest you check with @AK1, Andrzej of Coolabode. I needed assistance, and he was highly recommended by many folks on this forum for remote work. Add me to the list. Top notch service, knowledge, and availability! Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.