GaryGJr Posted December 13, 2016 Share Posted December 13, 2016 Is it possible to wire a dimmer and 6-button into an existing "dead end" three way setup? There is no neutral at the leg end of the existing three way. Link to comment Share on other sites More sharing options...
electrician9421 Posted December 13, 2016 Share Posted December 13, 2016 Yes it is possible to do I do this all the time. you would have to reconfigure the wiring at both ends of the setup. you would have to convert one of the wires to be a neutral one to be a power wire and the other to be signal wire between the switches. Link to comment Share on other sites More sharing options...
Matt Lowe Posted December 14, 2016 Share Posted December 14, 2016 so assuming you have two wires going over to the dead end side the 6 button would have to go there 1 wire your hot 2 wire your neutral the dimmer would then be installed as normal. the programming to toggle the light from the keypad can be done from composer HE, but a more versatile connection can be made via PRO Link to comment Share on other sites More sharing options...
Question
GaryGJr
Is it possible to wire a dimmer and 6-button into an existing "dead end" three way setup? There is no neutral at the leg end of the existing three way.
Link to comment
Share on other sites
2 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.