LED on buttons respond very slow

[diversitie]

The LED on buttons responded very slow (> 10 sec) although the zigbee signal strength are excellent and routing network look normal. How can I check and improve it? 

I noticed that there are some scenes containing a lot of load (> 15), are there relevant to the issue?

[Hardware]

You mean status LEDs on keypads?  Is your programming directly bound or "tap" based?  What is the reporting set for in those lighting scenes? 

[Matt Lowe]

Can you send some screen shots of the programming that changes the led lights.

how about packet loss on the devices. even if signal is strong you could have alot of interference causing packet loss.

 

[diversitie]

7 hours ago, Matt Lowe said:

Can you send some screen shots of the programming that changes the led lights.

how about packet loss on the devices. even if signal is strong you could have alot of interference causing packet loss.

 

How can I measure packet loss on the devices? Can you advise?

[diversitie]

On 5/6/2018 at 12:13 AM, Hardware said:

You mean status LEDs on keypads?  Is your programming directly bound or "tap" based?  What is the reporting set for in those lighting scenes? 

I never look at reporting set of lighting scene. Can you advise?

[Matt Lowe]

2 hours ago, diversitie said:

How can I measure packet loss on the devices? Can you advise?

if you can do it in composer it will be in network tools zigbee and then in the information for each load.