ronlonnborg Posted October 13, 2018 Posted October 13, 2018 I recently purchased a HC800. I have the HC250 as my Director and trying to add a SR250 remote. Current version is 2.10.4. The HC250 is the ZigBee Server and the HC800 is the Coordinator. It will not identify the SR250 remote. Have reset the remote with install battery with 4Button and 0 pressed. The remote was working fine when I had it on 2.9.1 and using my HC300C as coordinator. Sent from my iPhone using Tapatalk
sonic30101 Posted October 13, 2018 Posted October 13, 2018 press room off, #, *, 1, 3, 4, 1, 3 to make it leave the old network then re-identify
ronlonnborg Posted October 13, 2018 Author Posted October 13, 2018 Performed that and it says "Offlin" when I try to identify it.
Cyknight Posted October 14, 2018 Posted October 14, 2018 Did you change the mesh over? If so did you reboot after doing so?
ronlonnborg Posted October 15, 2018 Author Posted October 15, 2018 Did do a reboot several time. Even restore my HC250 and loaded 2.9.1 and put my HC300 back in to the project. Reconfigured ZigBee and BOOM. SR250 remote identified and working. Sent from my iPhone using Tapatalk
Cyknight Posted October 15, 2018 Posted October 15, 2018 So from here, do a zigbee mesh move, taking the HC300 out of that setup. Once you confirm it works after taht, you should b able to simply remove the HC300 and update.
Recommended Posts
Archived
This topic is now archived and is closed to further replies.