JMcNaught427 Posted April 3, 2019 Share Posted April 3, 2019 I just received a used CardAccess WMS10-C-ZP ceiling mount motion detector to use in a closet. The unit came without documentation, so I'm flying blind. Dealer has been unresponsive, so I asked a friend with ComposerPro to help out - thought it would be a simple task! I just want to ID the unit in CP. In ComposerPro Connections, pressing the WMS10 internal button 4 times does not cause the unit to ID as expected. Can't find docs online -- any ideas what I'm doing wrong? Using new battery, Red LED flashes when senses motion. Pressing button 4 times to ID, causes the Red LED to flash once and the Green LED to flash 3 times. But ComposerPro does not ID it, even when I enter the MAC address. Any ideas? Link to comment Share on other sites More sharing options...
msgreenf Posted April 3, 2019 Share Posted April 3, 2019 It's used and you need to reset it to leave the mesh. Also I strongly think you are "friends" with yourself. Cause you "friend" should know how to do this Sent from my Pixel 3 using Tapatalk Link to comment Share on other sites More sharing options...
dcovach Posted April 3, 2019 Share Posted April 3, 2019 It's probably on embernet firmware. If it's NOT an WMS10-2, it will for sure be on embernet firmware and will NEVER update to zigbee pro. Slap your "friend" for not telling you this. Link to comment Share on other sites More sharing options...
JMcNaught427 Posted April 3, 2019 Author Share Posted April 3, 2019 Forgot about 13 presses - all good now! Thanks. Link to comment Share on other sites More sharing options...
dcovach Posted April 3, 2019 Share Posted April 3, 2019 I think it was the slap that did the tick Anyways, it might be better to do a 9 button press to factory reset Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.