rf9000 Posted January 27, 2021 Share Posted January 27, 2021 All, I have been installing Control4 C4-KD120 keypads in my project and have come across four of them that seem not to work. These were taken out from a previous project. When connected, they dont light up and the top button does not control the load connected to it. Could these have programming that causes the LEDs not to light up and the load not to be activated? Or do you think they are bad? Quote Link to comment Share on other sites More sharing options...
dcovach Posted January 27, 2021 Share Posted January 27, 2021 Try a factory reset. 13-4-13 Quote Link to comment Share on other sites More sharing options...
JSTRONG Posted January 27, 2021 Share Posted January 27, 2021 Most likely they were fried by the previous installer not connecting them properly Quote Link to comment Share on other sites More sharing options...
rf9000 Posted January 27, 2021 Author Share Posted January 27, 2021 I did the reset and they work. Thanks guys 6 hours ago, dcovach said: Try a factory reset. 13-4-13 on which buttons? Quote Link to comment Share on other sites More sharing options...
dcovach Posted January 27, 2021 Share Posted January 27, 2021 43 minutes ago, rf9000 said: I did the reset and they work. Thanks guys on which buttons? Top (highest possible) and bottom (lowest possible) Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.