drmark12pa Posted April 2, 2022 Share Posted April 2, 2022 Just looking at purchasing a set of the Card Access wireless relays for my new house garage doors which are 2008 Liftmaster. I'm assuming one just connects the 2 relay points to the garage opener and the unit needs to have power to it (ie a 12v plug for example)? Any other help on this as I can't seem to find any manual or instructions online for use with a garage door open close application. Quote Link to comment Share on other sites More sharing options...
chopedogg88 Posted April 2, 2022 Share Posted April 2, 2022 I would use 1 Z2IO to control 2 door motors typically, as long as I can run a wire up through the attic from one motor to the other to hide it properly.Then for the door contacts you can use the NYCE wireless tilt sensors if you have a zigbee signal in there. Otherwise wired sensors from your alarm system or wired into another Z2IO. Pm me if you need further assistance. Sent from my SM-G986U using Tapatalk msgreenf 1 Quote Link to comment Share on other sites More sharing options...
drmark12pa Posted April 11, 2022 Author Share Posted April 11, 2022 So I've added the Card Access relay module (first picture) in Composer but as a Card Access relay there are literally no commands/actions (second picture). If I add a generic Control4 relay there is little in the way of adjustments under MONITORING but it appears that the actions of opening/closing garage door are there. Not sure why opening/closing wouldn't be available in the Card Access driver for this.... Am I missing something here using the Card Access Relay driver to perform the garage open/close function? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.