club411 Posted December 8, 2009 Share Posted December 8, 2009 I am trying to get it all setup before the installer comes. POE injector or switch? Does it have to be control4?Help the newbie out! Link to comment Share on other sites More sharing options...
thecodeman Posted December 8, 2009 Share Posted December 8, 2009 It's standard PoE. You can use either an injector or a PoE switch. Link to comment Share on other sites More sharing options...
club411 Posted December 8, 2009 Author Share Posted December 8, 2009 It's standard PoE. You can use either an injector or a PoE switch.any cheap recommendations? Link to comment Share on other sites More sharing options...
CFUG Posted December 8, 2009 Share Posted December 8, 2009 I use a D Link 1008 for three 7" units. Left-over from another job... Link to comment Share on other sites More sharing options...
ILoveC4 Posted December 8, 2009 Share Posted December 8, 2009 You can buy a PoE injector to use the switch you already have. They are about $25 each online, sometimes you can find them cheaper.That will be your least expensive route. Link to comment Share on other sites More sharing options...
thecodeman Posted December 8, 2009 Share Posted December 8, 2009 It's standard PoE. You can use either an injector or a PoE switch.any cheap recommendations? I made the mistake of buying a cheap & temporary switch for a job just to get it going, only to find out it wasn't on the "compatible network list" a week before I bought it - in fact, there's a KB article specifically stating to avoid it. So far, it hasn't crashed the system, but it will have to be replaced since we're utilizing all of the PoE ports already.Netgear FS726TP. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.