clange02 Posted April 7, 2012 Share Posted April 7, 2012 Is anyone else experiencing the email notifications not working and also the contact's not reading right. I am currently on 2.2 if i unplug the contacts on the back of the HC800 and plug it back in the contacts work for about 10 mins than stop again. The email notifications just wont work at all. If anyone has any insight on this help would be greatly appreciated. Link to comment Share on other sites More sharing options...
ILoveC4 Posted April 8, 2012 Share Posted April 8, 2012 RE: email notifications...how is the Director identified? Via IP or UUID? Link to comment Share on other sites More sharing options...
clange02 Posted April 8, 2012 Author Share Posted April 8, 2012 The Director is identified Via UUID. I also have reserved IP address for each controller on the network. Link to comment Share on other sites More sharing options...
alanchow Posted April 9, 2012 Share Posted April 9, 2012 Email notifications require an active 4sight service. Please review your 4sight subscription. Link to comment Share on other sites More sharing options...
clange02 Posted April 9, 2012 Author Share Posted April 9, 2012 I thought that might have been the problem but it is current. I also tried to un-register and re-register the controller. Link to comment Share on other sites More sharing options...
CFUG Posted April 9, 2012 Share Posted April 9, 2012 ^Check the tick box status "Enable Remote Access". Link to comment Share on other sites More sharing options...
clange02 Posted April 9, 2012 Author Share Posted April 9, 2012 The remote access is enabled as well. Link to comment Share on other sites More sharing options...
clange02 Posted April 9, 2012 Author Share Posted April 9, 2012 Well it appears I have both working again. I removed my HC-800 from the system and than added it back in than I did a complete re-start of my entire system. After completing the system is now working again. Thanks for all the response's my guess is this must be a bug its very strange everything was working for awhile than bang did not want to work must have been a union job :) Link to comment Share on other sites More sharing options...
CFUG Posted April 10, 2012 Share Posted April 10, 2012 I'm confused. You say it was a job done by others yet you can remove a controller and add it back? Link to comment Share on other sites More sharing options...
clange02 Posted April 10, 2012 Author Share Posted April 10, 2012 I meant because it just stopped working Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.