msgreenf Posted October 17, 2013 Share Posted October 17, 2013 Any ideas? I have tried Room off, #, *, 1, 3, 4, 1, 3 and never got anything. I tried doing a firmware swap too and that didn't work. Link to comment Share on other sites More sharing options...
ILoveC4 Posted October 18, 2013 Share Posted October 18, 2013 I think is * first, pound second.Room Off, *, #, 1, 3, 4, 1, 3.I could be wrong though. Link to comment Share on other sites More sharing options...
Godzilla Posted October 18, 2013 Share Posted October 18, 2013 # is 1st after room offperhaps is not connected to a mesh Link to comment Share on other sites More sharing options...
msgreenf Posted October 18, 2013 Author Share Posted October 18, 2013 well i can't get it to join my mesh. I try pressing the "4" 4x and that doesn't work. i try manually entering the address and it doesn't work. Link to comment Share on other sites More sharing options...
ILoveC4 Posted October 18, 2013 Share Posted October 18, 2013 Is it on embernet? Link to comment Share on other sites More sharing options...
msgreenf Posted October 18, 2013 Author Share Posted October 18, 2013 Is it on embernet?I don't think so. I tried ember net upgrade and that didn't work. Link to comment Share on other sites More sharing options...
kajphotos Posted October 18, 2013 Share Posted October 18, 2013 Try factory reset Link to comment Share on other sites More sharing options...
msgreenf Posted October 18, 2013 Author Share Posted October 18, 2013 Try factory resetHow? I tried the factory reset as listed in the dealer kb and that doesn't work. I also can't get a firmware swap to work. Link to comment Share on other sites More sharing options...
Cyknight Posted October 19, 2013 Share Posted October 19, 2013 The one you typed here is not really a factory reset, it's leave mesh.Factory reset -which from your first post I assume you tried by the way- is press and hold "0" and "Control4" while putting in the batteries.I've had a handful of these situation though - those that I managed to fix vs replace were done by leaving batteries out for an hour or so, then back in while doing a factory restore/re-image as per above.But there really isn't much else to try unless you want to go into the over obvious (try different batteries, have ID window open while putting in the battereis) Link to comment Share on other sites More sharing options...
msgreenf Posted October 19, 2013 Author Share Posted October 19, 2013 I tried doing the image swap (0 + "c4") and got nothing..... Link to comment Share on other sites More sharing options...
msgreenf Posted October 22, 2013 Author Share Posted October 22, 2013 any other thoughts? !? Link to comment Share on other sites More sharing options...
Godzilla Posted October 23, 2013 Share Posted October 23, 2013 yea.........RMA it Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.