Nehsmit Posted November 19, 2013 Share Posted November 19, 2013 Hey all I was trying to install an old c4 ddimmer and it was working fine but at some variation of wiring I heard it click? Since then the leds have no power. I checked the circuit breaker but that is fine. I pressed the top button 15 times but no help. Any thoughts on this?Thanks in advance. Link to comment Share on other sites More sharing options...
ILoveC4 Posted November 19, 2013 Share Posted November 19, 2013 You were doing the wiring with the circuit HOT? You're more brave than I am. Sounds like you wired it up wrong. Link to comment Share on other sites More sharing options...
Nehsmit Posted November 19, 2013 Author Share Posted November 19, 2013 No not hot. Circuit off then wired. Then circuit on. So is it fried? Link to comment Share on other sites More sharing options...
RyanE Posted November 19, 2013 Share Posted November 19, 2013 If you power it up and get *no* LEDs coming on, it's likely toast. Sorry. RyanE Link to comment Share on other sites More sharing options...
Nehsmit Posted November 20, 2013 Author Share Posted November 20, 2013 Any way to fix it? Link to comment Share on other sites More sharing options...
CFUG Posted November 20, 2013 Share Posted November 20, 2013 ^Write it off as a lesson learned. Don't mess with electricity without full knowledge. I've never crossed wired one of those (and never will) so I can't say that's why it fried. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.