Shardik
-
Posts
90 -
Joined
-
Last visited
Reputation Activity
-
Shardik reacted to zaphod in Amp suggestions
A used 4 zone Control4 matrix amp from eBay would be another option.
-
Shardik reacted to booch in Amp suggestions
Jamo JDA500 DSP? I have a bunch of the Klipsch versions (same hardware AFAIK) and they do well. Think you can pick one up just under $500. Theres a driver too (not that it’s needed).
If you need more than pure amplification (can’t tell), you could pick up a late model Sonos on eBay, I’d assume.
-
Shardik reacted to andypaul in DSC NEO Integration
Any changes that you or a tech made that may have triggered an issue?
The Alarm will report a problem if it is not communicating with the network if it is not retorting a problem then the TL280 receiver may have been disabled.
The TL280 has Communicator Status LED's that indicate error situations have a look at these and correlate them to the TL280 manual.
I have had the following issues previously:
- Electrician wired a data cable 1 is to 1 as in not to T568A or T568B spec the TL280 didn't like this
- Alarm tech wired the ribbon cable to the TL280 from the main alarm board inverted
- The TL280 receiver board was disabled in the Alarm setup
- Change of any of the Installation Info in the TL280 Control 4 Driver
- Change in the IP Subnet while the TL280 has a Static IP Address
Hope this helps.
-
Shardik reacted to ejn1 in DSC NEO Integration
i think there is an extension you can purchase to position it away from the panel.