Jump to content
C4 Forums | Control4

Unable to identify thermostate


Recommended Posts

I'm using a hc-250 controller with control4 thermostat .all other devices identified just fine. but no luck with the thermostat.

It is not a zigbee signal issue because I tried it with the t-stat right near the controller. It doesn't seem to be a t-stat issue because I have tried 2 different t-stats both with the same results... any advice?

Link to comment
Share on other sites


far left button tap 13 times, center button 4 times, far left button 13 times. Do that and you should see it leave mesh in upper left corner. Once thats done you can add it assuming you have composer pro and access.....

 

Become very familiar with the 13-4-13 process. Or 9-9-9

Link to comment
Share on other sites

  • 2 weeks later...

good advice .... is it left button as you look at the unit?

It's actually the left button when look at it upside down, and back words.

If you're looking at the front of it, and it's right side up, then yes - the left button is the one on the left.

Sent from my Droid MAXX via Tapatalk.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.