chesterwilson Posted September 16, 2014 Share Posted September 16, 2014 So I have Sonos all setup but have the input going to my hc300 so my speakerpoint's can also play. The difference in volume is much different between Sonos and Rhapsody. Is there any global way I can change the volume for the room if Sonos is selected? I can do it individually for each room but it's more labor intensive. Anyone know a shortcut? Link to comment Share on other sites More sharing options...
Cyknight Posted September 16, 2014 Share Posted September 16, 2014 Are you using a variable or fixed volume output? If variable make sure the volume isn't to far down on the SONOS Link to comment Share on other sites More sharing options...
chesterwilson Posted September 16, 2014 Author Share Posted September 16, 2014 Are you using a variable or fied volume output? If variable make sure the volume isn't to far down on the SONOS Thanks, i will just change it to variable and adjust the volume there! Link to comment Share on other sites More sharing options...
Cyknight Posted September 16, 2014 Share Posted September 16, 2014 PS, no there isn't any easy way to do this in programming.Hope the variable output works a bit better for you. Link to comment Share on other sites More sharing options...
Matt Lowe Posted September 17, 2014 Share Posted September 17, 2014 you can just the program the volume to a low level on audio changes then increase as needed Link to comment Share on other sites More sharing options...
Cyknight Posted September 17, 2014 Share Posted September 17, 2014 you can just the program the volume to a low level on audio changes then increase as neededchange the volume for the room if Sonos is selected ? He is asking about the ability to program based on source (so he doesn't HAVE to manually change the volume for a specific source because it's lower) - you're recommending the opposite (in other words status quo)? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.