Jump to content
C4 Forums | Control4

Run macro on start-up

Mr .Flibble

Recommended Posts

The reason is that the controller goes to a default state.

Yes you can run any programming on startup - but be sure to add a DELAY in front of it all so the whole sytem has a chance to restart (it's on project load, not 'system is up and running')


Better in your scenario would be to flip the wires on the gate control from what I assume is NO to NC (driver settings would ave to be changed too mind you!)

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...

Important Information

By using this site, you agree to our Terms of Use.